Part Seven: How to connect the sound and light unit (SLU)with the remote control receiver (RCR), electronic speed control (ESC)and steering gear (SG).

Part Seven
Products link instruction:

I believe you have get some information about the function of each part of the multi-function sound and light unit (SLU). The following steps will show you how to connect the SLU with the remote control receiver (RCR), electronic speed control (ESC)and steering gear (SG), which are need to be purchased separately.
(1) the connection on the electronic speed control with the SLU
The steps can be save if you open the switches both of SLU and ESC; if not, the steps will get that the switch of the ESC can be controlled by the switch of the SLU.
In this process, you need a tool: Hair Dryer.
The connection steps are as follow:
1. After removed the switch on the ESC, you need also to remove the top tip of the wire, such as the follow picture One:

2. You need to twist the gray and purple lines in the switch of the SLU on the two wires(lines) in the Picture two(no order requirement).

                             Picture One and Two


3. Put heat shrink tubes on the two joints separately, as Picture Three.

4. Use hair dryer blow the heat shrink tubes and make it shrink the joints tightly and play an insulation role, shown as Picture Four.

                        Picture Three and Four




(2) Power Link
As Picture Five shows, Connect the battery, SLU and ESC with the power line whose joint insert on the connector of SLU.

(3) The connect of the switch of the SLU.
As the Picture Six show, insert the switch on the connector(SW).

                          Picture Five and Six


(4) Horn Connection.
As the Picture Seven shows, insert the horn interface into the joint of the SLU(SPKER).

(5) The connect of Volume Regulator.
As the picture Eight shows, insert Volume Regulator into the joint of the volume regulator of the SLU (SNDADJ).

 

Picture Seven and Eight 

(6) The connection of the Light Accessories: 25 super LED

As the following Picture Nine shows, insert the light accessories of LED into the Light joint (VEHICLELGT).

                                      Picture Nine

(7). The connection of the receiver.

Four Access Rocker
If you are using Four Access Rocker, congratulation, you can control all parts of SLU and we will give you details in following step.
SLU provides four input access for receiver signal, and needs to connect with four accesses on the receiver which will changed following the Control Rocker.
The connection way will effect your result of remote control your car. Now we recommend you a method as follow:
Firstly, we explain the control rockers and its related output accesses on the receiver. Please have a look at following picture:

                      Picture 10: The rocker and the related accesses

From the above picture, we can get that: UP and Down on Left Rocker with ELEV Access, Left and Right on the Left Rocker with RUDD Access; UP and Down on Right Rocker for THRO Access; Left and Right on the Right Rocker with AILE Access.

And the corresponding relationship: The Receiver Access One to AILE; Access Two to ELEV; Access Three to THRO; Access Four to RUDD.
Next, we can have a look at the signal input joint of the receiver on the SLU as following picture:

                       Picture 11 signal input joint on the receiver.

1st on the left: 1 ST: turn signal input joint.

2nd on the left: 2 TH: hrottle signal input joint.

3rd on the left: 3CH: function selection signal input joint;

4th on the left: 4CH: function operation signal input joint.


Reported from Taobao Agent: Buychina.com